1066 universal transmitter for water analysis

Description
Table

This analytical device powered from external boundary is applied in industrial, commercial and municipal areas. The device supports a wide range of incoming data for liquid analysis, as well as the possibility to connect two-wire analytic transmitter.
1066 SMART analyzer supports continuous metering by one of liquid’s analytical data input. Device design ensures simple access to its internal components, as well as wire connections.

Large display ensures high-quality displaying of parameters and measurement results in real time. For convenience purposes, real-time measurement data are always shown on the display during adjustment and calibration.

In-built preamplifier with SMART technology for electrochemical analog sensors.

Technological information and specifications
Casing material	Polycarbonate. NEMA 4X/CSA 4
Dust and moisture protection	IP66
Cable conduit openings	Six. It is possible to use 1/2 inch fitting or PG13.5.
Display	Monochrome graphic LCD. Without backlight, resolution: 128 x 96 pixels.
Ambient temperature and humidity	from -20 to 65 °C, relative humidity (RH) from 5 to 95% (without condensation).
Storage temperature	from -20 to 70°C
HART® communication channels	PV, SV, TV and 4V variable can be assigned with measurement values, temperature and any other HART diagnostics data updated in real time.
RFI/EMI (radio frequency/electromagnetic interference)	EN-61326
Input	Single electrically insulated input from sensor.
Analog outputs	Two-wire loop-powered output (only output 1). Two electrically insulated current outputs 4-20 mA (external power shall be directed at output 2). HART digital signal, fully scalable within the operating range of the sensor, is overlapped on output 1.
Power and load requirements	At least 12.7 V DC. Power supply voltage shall compensate voltage drop in cable and the external load resistor required for connection via HART protocol (minimum resistance 250 Ohm).
Weight/shipping weight	rounded to 0.5 kg /1.5 kg
Dimension	155 x 155 x 131 mm

In-built preamplifier with SMART technology for electrochemical analog sensors.

Technological information and specifications
Casing material	Polycarbonate. NEMA 4X/CSA 4
Dust and moisture protection	IP66
Cable conduit openings	Six. It is possible to use 1/2 inch fitting or PG13.5.
Display	Monochrome graphic LCD. Without backlight, resolution: 128 x 96 pixels.
Ambient temperature and humidity	from -20 to 65 °C, relative humidity (RH) from 5 to 95% (without condensation).
Storage temperature	from -20 to 70°C
HART® communication channels	PV, SV, TV and 4V variable can be assigned with measurement values, temperature and any other HART diagnostics data updated in real time.
RFI/EMI (radio frequency/electromagnetic interference)	EN-61326
Input	Single electrically insulated input from sensor.
Analog outputs	Two-wire loop-powered output (only output 1). Two electrically insulated current outputs 4-20 mA (external power shall be directed at output 2). HART digital signal, fully scalable within the operating range of the sensor, is overlapped on output 1.
Power and load requirements	At least 12.7 V DC. Power supply voltage shall compensate voltage drop in cable and the external load resistor required for connection via HART protocol (minimum resistance 250 Ohm).
Weight/shipping weight	rounded to 0.5 kg /1.5 kg
Dimension	155 x 155 x 131 mm